Based on your request, I would like to show why DIY arduino drone resets (or restarts) itself when increasing or Giving Throttle.
This could be caused:
1. You dont shorthen wires in the circuit
2. Wrong wire choice (I recommend you to use only AWG 28 since it works best)
3. Insufficient power from power supply to board.
Since we use step-up booster module as DC-DC power regulator module (3.7v to 5v) then in this video we check both Input voltage and Output voltage to see if there is something wrong with the power supply.
Battery specs: 3.7v /4.2v DC 80C 450mAh LiPO Battery
Voltage needed to power flight controller = 5v DC
Voltage needed to power motors directly = 3.7v to 4.2
(note: battery with more than 3.7v for 720 coreless DC motor will cause heat).
#troubleshooting #arduinodrone #multiwii #quadcopter #drone #diy #ardujimmy
[ad_2]
source
